Milk 2%
This Guide will help you build your Milk2% macropad kit.
PHOTO HERE
0 - What you need
- Solder Iron
- Solder wire
- Soldering skills
- A computer in order to flash the firmware (MacOS, Windows, Linux)
1 - Solder pin headers to the pcb
Make sure to solder the ehaders in the right side of the PCB as shown.
PHOTO HERE
2 - Insert switches and solder switch pins
Insert the switches in the macropad, carefully in the right orientation as shown, position the PCB in the Milk case in the right side with headers facing up and with the label This side up and towards port facing the USB hole of the case.
PHOTO HERE
Now Solder the switches' pins
PHOTO HERE
3 - Solder the microcontroller
Make sure of which microcontroller you are using, this tutorial shows a Promicro32u4 and Helios RP2040, follow the right part!
3.1 ProMicro ATMel32u4
Position the microcontroller facing up (with the chip showing up), solder the needed pins.
PHOTO HERE
3.2 Helios RP2040
Position the microcontroller facing up (with the chip showing up), check the photo for the pin position as the Helios has an extra row of pins.
PHOTO HERE
4 - Flash the firmware on your microcontroller
Like step 3, this one too has 2 different paths depending on the microcontroller you have.
4.1 - ATMel32u4
Flash your firmware with QMK blablablabla... link firmware
4.2 - RP2040
Connect the RP2040 to your computer, it should show up as a RaspberryPi memory drive.
Copy ZanniKB's ARM Firmware available from HERE in the root memory off the RP2040.
Your microcontroller will automatically reboot after the file has finished transferring.
5 - Configure your macropad
Using VIA you can now set custom macros or keys to your macropad.